KRELL 707, HDMI input and output (including audio and video) does not respond!

The early Krell Evo 707 had problems with HDMI handshake. It may work with some HDMI sources and not with others or it may simply not work with any HDMI connection. Try switching off the main power switch on the back lower left of the unit for a minute then switch back on. This will reboot the unit and it may help. I advise against opening the unit. This has nothing to do with unclean contacts.

The 707 is a hand built ultra high end pre/processor. It can be quirky. It is a bit slow (short delay) to pick up full digital audio signals via HDMI.

I have owned my 707 for over 12 years. I have had to bring it back to Krell for repairs a few times, which is a pain in the neck. However, it is a fantastic sounding processor; super fast, life-like, vibrant, clear, clean with tight deep clean bass. It is the best upgrade I have ever made to my music/home theater system in all my 45+ years in this hobby. I doubt there is a better sound processor on the market. I have upgraded my unit with the external Krell 4K switcher. It works great with my new 4K Sony 83" A90J OLED. My guess is you need a new video board. Call Krell support.

How long have you owned your Evo707?

 

 

 

 

HDMI boards seem to be a pretty common failure point in many AV processors and receivers.  I don't know about issues with Krell in particular.  You might try posting the AVSForum, there's more focus on home theater in that forum.

You might try removing the HDMI board and cleaning the contacts with contact cleaning solution.  The HDMI board can be removed  by removing two screws on back.  The top cover has to removed so that you can carefully push the circuit board out. Give this a try before send the unit in for repair.

Does this happen on all HDMI ports?  Something to check.  Otherwise, you are better off sending it to Krell for repair.

Wow, KRELL!

Great brand with impressive performance.

If the unit is still under warranty, you should be able to get it serviced by KRELL.

My advice - be careful and use a hair dryer - COOL setting on the HDMI port. Buy a new HDMI cable or use a spare to test It again.

Upon 2nd failure after this, unplug all cables from the unit. Make sure it is powered off and unplugged from power before doing this. Wait for 10 minutes. Then test again.

This should not be happening on such a high-end piece of gear. If it still doesn’t work, then it is definitely a port issue. You cannot repair this yourself and will need to contact KRELL.