Do the plate amps also have speaker (high level) connections? If so, you should be able to run a set of speaker cables to your subs from the same speaker connections on your amp that your monitors are hooked to. The high level sub inputs are generally high impedance, so the amp will easily drive this load. Adjust the crossover level on the subs (lower usually blends better). The monitors will run full range. I have my sub hooked up this way with my Magnepans, and it sounds better than using the low level (RCA) input.
L&R subs but only only a mono sub output; options?
This may be difficult to explain correctly but I may be in a situation where I have two subs and two monitors functioning as L&R main speakers. The subs will have plate amps with RCA inputs but I can only output a split mono sub signal from my receiver. I don't want to go this route since I will loose the stero effect for anything below the crossover point which may be higher than usual due to the overall design.
The only other full range signal that I have available would be the preout for Zone 2. In theory i could run the zone 2 preout to the sub to deliver the signal and use the crossover on the plate amp. The trouble here is that zone 2 only plays analog inputs which means connecting up analog cables from my BD player and cable box...not a problem in itself but will there be timing issues in the output signal due to the different processing and delivery of the inputs?
Hope this makes sense and looking forward to feedback and suggestions.
Thx.
The only other full range signal that I have available would be the preout for Zone 2. In theory i could run the zone 2 preout to the sub to deliver the signal and use the crossover on the plate amp. The trouble here is that zone 2 only plays analog inputs which means connecting up analog cables from my BD player and cable box...not a problem in itself but will there be timing issues in the output signal due to the different processing and delivery of the inputs?
Hope this makes sense and looking forward to feedback and suggestions.
Thx.
- ...
- 5 posts total
- 5 posts total