Loud Hum from DNA 0.5

I'd have to turn up the system fairly loud to not notice it.

so that hum noise was THAT LOUD????
I had the same issue within my setup. It was humming because of the cable tv coax cable, but it wasn't that loud. Anyway, look for ground loop isolator. 1 example is the Mondial MAGIC(Mondial Antenna Ground Isolation Circuit) box. YOu can find similar products cheaper. I bought this one sometime ago.
Doesn't degrade the picture quality on my Hi-Def and the hum is completely gone.

sorry about the double post...my 1st one didn't show up at first.

I just discovered that the coax for the tv was still in contact with the connector on the cable box. After removing it completely, the hum went away. Apparently, I need to get the cable TV grounding filter.

I stand corrected! Thank you so much Steve! I had disconnected the cable tv from the back of the cable box but when I pushed it back on its shelf, the cable was still in slight contact with the connector. I realized that if I removed the coax cable away from the cable box, the hum disappeared. Looks like I need to get a cable TV ground.

In reading over the counter point article, the DNA is the only component with 3 prongs. The DVD player, AV receiver and TV/Cable box only have 2. Even with the cable tv disconnected from the wall, the hum persists.

I tried disconnecting everything from the receiver other than the DNA and the hum is still present. The AV receiver only has a 2 prong plug. I can try getting the converter for the DNA to see if that solves the problem.

Hi Taylormade2 -

Sorry to hear about the problem with your DNA-0.5. I have no idea what work was done on your amp, but it seems possible that the factory updated the Earth / main-board ground path while doing the repair work. This would normally be a good thing, but it may have gone awry in your particular setup.

If the amp were "broken," I would expect to hear noise constantly, even with no input cables connected. You say that the noise disappears if you remove the interconnect cables, and this suggests a ground loop. Try "floating" the earth ground connection on the amp by using an AC "cheater" plug (3-to-2 connection adaptor). These are available at your local hardware store. In addition, if you have any kind of an audio connection to a cable TV video system, disconnect it. If the hum disappears, you have been dealing with a ground loop. For a more complete explanation, go here: http://www.altavistaaudio.com/hum.html

Good luck!

Best regards,

Steve McCormack
www.SMcAudio.com

Also, I should clarify that the hum is loud enough to make the amp useless. And regarding the preout noise, prior to repair, there was no hum and prior to the DNA 0.5, the Rotel amp produced no hum.

Also, I'm using Vandersteen 2Ces so I can't look at the drivers.

Thanks for the input. Yes, it's the same receiver used prior to the repair. The system was essentially untouched other than using the receiver to power the speakers while i was waiting for the repair. I guess I'll have to wait until Monday to call McCormack.

Sounds like a grounding problem to me. I would call McCormack and have them walk you through checking the grounds. I'd say it is chassis grounded and they left one disconnected off the power supply board when they reinstalled it.

Or it could be DC. Look at your speaker's woofers from the side when you hear the hum. If you drivers stick out during the hum (it will be obvious), then you have DC on the outputs. Call McCormack for this too.

However - was the Yamaha the same one you used with the 0.5 before the cap repair? I knew a Denon receiver that had pre-outs that hummed like crazy.... Pre-outs are not a top design priority in receivers.

Arthur