Loud Hum


I recently bought two Brystons 7Bst's to power my Revel Salons. I also have a Bryston 1.7 and I am getting a LOUD hum from ALL speakers (I run the center and rears with a Proceed HPA 3 while I purchase other 7BST's). The Proceed did not make the HUM while I was using it to power the two Salons and center channel, but now that I am using it to power the center and surrounds it is VERY loud. My Revel B 15 ALSO has the HUM (although not so loud).

Any suggtestions?

Thank you!
dynasys
Turn off all equipment & unplug everything. (This also gives you a chance to clean/check all connections) Start over but just connect the spkrs to the 7BST's. If there's a hum, there's your problem. If not, go through the hook-up sequence one piece at a time until you locate. Make sure to turn off all gear everytime you connect/disconnect.

It's been my experience if it's not the component itself the AC is the culprit and most of the time it's the AC & not the component. If it turns out to be the AC, do a search through the archives for ways to address this. Good luck.
Step one. If you have satellite or cable TV ,disconnect the coaxal line from your set top box and tell us if the hum goes away.
Thank you Driver. I will try that. I also just noticed that my lights (overhead) that have a dimmer are making a hum. I have both Brystons on a dedicated power line. I will try disconnecting everything.

Thank you Darrylhifi. I do not have satellite or cable connected.

Any other suggestions?
If anything is on the same circuit as the dimmers, it'll introduce noise & it might even backfeed into your dedicated lines if everything shares a common ground at the panel. The only true dedicated lines are completely isolated, including the ground.

When I ran sound on the club circuit, I learned early on to avoid dimmers/fluorescents like the plague, as dirty AC was the biggest detriment to good sound. Same thing holds true in your house. I also recently had an electrician check out my circuit, as I could hear a buzzing through the spkrs. that I hadn't noticed before. He tightened up the ground in the panel, as my dedicated lines share the ground with the rest of the box. Just that little bit helped eliminate the buzz & I can only hear the slightest hiss now if I put my ear right up next to the driver. If you aren't sure what to do re: tightening the ground or anything for that matter at the panel, do not attempt to, as this electrician, who also happens to be an audiophile, told me more people are electrocuted in their own homes trying to do repairs than anywhere else.
Is it dimmer hum of ground loop? Good explanation at[http://www.audioadvisor.com/store/productdetail.asp?sku=TRIBGG1&product_name=Ground%20Guard%201%20Ground%20Loop%20Eliminator] Turn off dimmed lights. Hum? Unplug cable. Hum? Ground loops (caused by the cable being grounded at a different potential from your electrical cable) can also be at your equipment. Unplug all video RCAs. If there is still hum, use 3 to 2 prong "cheater" plugs from the hardware store to remove grounds from all bu preamp. If the hum is from video you may need cheaters and cable ground isolator on video grounds.