Most Beneficial Cable Upgrade

The last three feet are the most important because that is last section of cable that influences the signal right before it enters the power supplies in your components. Think of all the crap that can contaminate your water. A good filter at the tap will remove 99.999% of the impurities right before it touches your lips. Do you trust the water that flows through 60 miles of pipe that is 50 to 100 years old? I personally do not.

A properly designed cable "can" I did not say "will" (depending on the quality of your equipment and your ability to perceive changes), improve and enhance certain frequencies, lower the noise floor, increase resolution, etc, etc. I am not trying to convince you one way or the other.. Your own ears and experience is more valid than anyone on a forum.

It is possible that the reverse could also happen== bad sound. So much of what we do and experiment with in audio is system dependent and user dependent. We call that SYNERGY. That is one reason why we have forums here and elsewhere and 15,000 manufacturers. There is room at the bar for everyone! All opinions are valid to the owner of said opinion. Just because someone cannot detect a difference does not prove that it does not exist or is not valid to those who do. There are too many things in this world that cannot be proven or seen but we understand them to exist(ie God particle, string theory, anti-matter, miracles, faith).

The best part of all of this is>>>... Try as many of the cables and products as you can from vendors that will allow a 30 or 60 day trial. If you do not hear any differences or perceive any gains you can send them back. Put your stock cables back in and laugh all the way to the bank. Think of how much money you saved and how much time you can now devote to listening to your music and not worrying about making it sound better.

Not having "Golden Ears" can be a blessing, Can it not?

Some things I did not mention in my previous post.

IMO what I said above can apply to interconnects and speaker cables also.

AC treatment and proper grounding are very important.

Be practicle, treat one problem at a time and try to keep an open mind, remember your budget.

If and when you do try cables try to find something in the middle of a manufacturers line up. That is usually where the best bang for the buck can be found. (trickle-down).

Lastly, be careful. If you do find that you can detect differences between cables and components and things start to sound better, clearer, more musical, more like the real thing... then you are screwed! The Merry-go-round will have just begun and your conversion to the dark side is just one upgrade away:>) Good Luck with your journey!!!!

There is a lot of subjectivity here. But one cable that is extremely important and must be taken care of is the interconnect from source to preamp. It is true for every system.

However in my system it is the power cord to the source that does the most.

In my experience the most important have been the interconnect from the source, speaker cable, and the power cord to the source.

In my system, it seems as though the preamp to amp interconnect makes a big difference.