Mounting Triplanar Tonearm to SME 20/2 Turntable
My suggestion is make a new aluminum arm board for your arm. https://www.etsy.com/listing/194959127/aluminum-round-disc-circle-6061-250-14?gpla=1&gao=1&&... https://www.gcaudio.com/images/uploads/777/sme-20-diagram_square.jpg |
@atmasphere Thanks for your advice, Ralph. I appreciate it because I know you own a Tri-Planar and it was your recommendation on these forums that I began researching them. For the record, the plinth of the SME deck is not the same material as the arm board. The arm board looks like machined aluminum. The plinth is something else, I'm not sure the material. I'm considering making the existing arm board work, but haven't decided yet how. Tri Mai says he can help me figure this out if I want to go this route. I've also contacted SME about ordering a blank arm board from them. I'm assuming the price for this will be more than I want to pay. They charge $9 for one of their own hex wrenches (standard metric sizes), as an example of how over priced their accessories are. One can only assume the arm board will be hundreds of dollars. That said, if going this route is the best way I will spend the money. @imhififan Thanks for the link to the etsy listing. That would likely work just fine and be very affordable. @millercarbon Thanks for the suggestions. Much appreciated. I like the idea to experiment with different materials. |
Three choices. #1 buy a new tonearm board. #2 laminate 1/2" MDF to the current tonearm board to cover the hole. Spray paint it black and make sure you can lower the new arm enough to get it down to platter level. #3 Make a new tonearm board. Layer plastic and aluminum layers to get the right thickness using slow set epoxy. Use the old board as a temple to router the board to exactly the same shape. If you don't have the stuff to make your own just buy a new one. |
Right???@millercarbon I do talk with the voice of authority fairly often, which probably isn't the best way to present things. But I try to temper that with simply not responding if I have any doubts. FWIW dept.: I own two Triplanars and Triplanar is a 10 minute drive from here. We also make a turntable - the model 208. I've serviced turntables of all types as I put myself through engineering school repairing consumer electronics. So I was expressing the mechanical engineering issues that are common to all turntables. This issue is not unlike the steering in a car. The car has to keep the wheels on the road at all times, and at the same time you have to be able to steer it. To do this, there can't be any play or flex in any of the steering or suspension components or else the handling can get creepy really fast. In a turntable, there can't be any play between the surface of the platter and the locus in which the cartridge is held. If there is, the stylus will be able to move in a way other than the grooves of the LP dictate (introducing chatter and/or coloration). To this end there can't be slop in the bearings nor flex in the plinth. The arm has to be rigidly coupled to the platter bearing - as rigidly and also as 'dead' as possible (the latter being why damping a plinth affects the sound). Otherwise that would be much like a flexible part in the steering of the car- and would result in the wheels not doing what you want. |
I mounted a Triplanar on a SME 10, you @snackeyp might of bought the arm from me? Any how I had an armboard made of Delrin by Brian at Analogue Artisan and worked great he is in New Hampshire and does very good work. If you look at my profile I put some photos of it there. I found it difficult to work with Triplanar as far as getting an arm board
http://www.analogueartisan.com/
|
