NAD C399 connected to the Nalai Hypex 500 Monoblocks as a preamp.

Hello Guru's,

Need some help with specs to make sure these two are compatible. NAD SPECS:

PREAMPLIFIER SECTION LINE INPUT, PRE-OUT (Analog bypass on) THD (20 Hz – 20 kHz) 106 dB (IHF; A-weighted, ref. 500 mV out, unity gain) Channel separation >100 dB (1 kHz) >90 dB (10 kHz) Input impedance (R and C) 56 kohms + 100 pF Maximum input signal >4.6 Vrms (ref. 0.1 % THD) Output impedance Source Z + 320 ohms Input sensitivity 65 mV (ref. 500 mV out, Volume maximum) Frequency response ±0.3 dB (20 Hz - 20 kHz) Maximum voltage output -IHF load >5 V (ref. 0.1 % THD

NILAI SPECS

Specifications

• THD+N:  0.00015% (-116 dB) @ 100W / 4Ω / 20 – 20.000 Hz
• 260W  @ 8Ω, 1 kHz, THD < 1%
• 525W  @ 4Ω, 1 kHz, THD < 1%
• 500W @ 2Ω, 1 kHz, THD < 1%
• Frequency response:  0-70 kHz
• Output noise:  9.5µV @ 11.8 dB gain
• Gain adjust in three steps:  11.8 dB, 21.8 dB and 27.8 dB
• Signal to Noise:  134 dB
• Input Impedance: 47 kΩ
• Idle power:  14 W typical 

Thanks,

Anthony

.