Specs seem fine. The key question is if the sound characteristics of the NAD synergize well with the amp for your particular tastes/preferences and within the context of your system.
NAD C399 connected to the Nalai Hypex 500 Monoblocks as a preamp.
Hello Guru's,
Need some help with specs to make sure these two are compatible. NAD SPECS:
PREAMPLIFIER SECTION LINE INPUT, PRE-OUT (Analog bypass on) THD (20 Hz – 20 kHz) 106 dB (IHF; A-weighted, ref. 500 mV out, unity gain) Channel separation >100 dB (1 kHz) >90 dB (10 kHz) Input impedance (R and C) 56 kohms + 100 pF Maximum input signal >4.6 Vrms (ref. 0.1 % THD) Output impedance Source Z + 320 ohms Input sensitivity 65 mV (ref. 500 mV out, Volume maximum) Frequency response ±0.3 dB (20 Hz - 20 kHz) Maximum voltage output -IHF load >5 V (ref. 0.1 % THD
NILAI SPECS
Specifications
- THD+N: 0.00015% (-116 dB) @ 100W / 4Ω / 20 – 20.000 Hz
- 260W @ 8Ω, 1 kHz, THD < 1%
- 525W @ 4Ω, 1 kHz, THD < 1%
- 500W @ 2Ω, 1 kHz, THD < 1%
- Frequency response: 0-70 kHz
- Output noise: 9.5µV @ 11.8 dB gain
- Gain adjust in three steps: 11.8 dB, 21.8 dB and 27.8 dB
- Signal to Noise: 134 dB
- Input Impedance: 47 kΩ
- Idle power: 14 W typical
Thanks,
Anthony
.
- ...
- 5 posts total
@imhififan Of course that’s up to the OP. That should be understood. |
I appreciate your feedback, Only time will tell. I originally wanted to get my hands on the NAD M 33, but at $3000 difference in price, it seems like a hell of a bargain. I will be getting the monos in on Friday. I wanted the power of the M33, at least I hope so, combined with the BluOS, Dirac and other goodies of the NAD 399. Thanks gentlemen! |
- 5 posts total