Very few have done wrong by using tubes over transistors. My (now unused) 70watt KT88 tube amp drove my Spendors to deafening levels with serious bass. The Polks being 88dB at 8R should sound great with even a 30w integrated tube amp especially if the OP isn't cranking it.
Need some Amp help - a little new to properly powering speakers
Hello.
I have some polk LSIM707s that I thorough enjoy.
However, at the moment I'm powering them using a Yamaha aventage 3070 receiver which at 150 watts at 8ohms sounds pretty darn good.
However, since these are rated at 300 watts at 8 Ohms, I assume I will need some more power. I notice at lower volumes a lot of the imaging and clarity disappears.
I am looking at buying a 300 watt emotiva Amplifier, or a 500 watt emotiva amplifier.
I'm assuming it would be better to purchase the 500 watt per channel emotiva so the speakers won't suck it dry or stress it.
Am i wrong in this assumption?
I have some polk LSIM707s that I thorough enjoy.
However, at the moment I'm powering them using a Yamaha aventage 3070 receiver which at 150 watts at 8ohms sounds pretty darn good.
However, since these are rated at 300 watts at 8 Ohms, I assume I will need some more power. I notice at lower volumes a lot of the imaging and clarity disappears.
I am looking at buying a 300 watt emotiva Amplifier, or a 500 watt emotiva amplifier.
I'm assuming it would be better to purchase the 500 watt per channel emotiva so the speakers won't suck it dry or stress it.
Am i wrong in this assumption?