Need to replace my Rotel RMB-1095 . suggestions pls

7 business days after receiving my amp, I called the service center for an update.  The front left channel board fried almost all of the transitors and resistors.  The glue on the front right channel needs replacing as well. They stated they try to use original or as close to original components as possible. They also menitoned that some people prefer both channels to have the same components and as an option, I could ave the right channel board "repared" with similar components if I felt I might hear a difference.
Not sure if sonically I would notice but figured getting both boards fixed/re-freshed would be a good long-term investment.
approx total cost (inc shipping) will be $800.  Hope to have it in 2 weeks

Got my Amp back today.  took 40 days and total cost $1,009.16.  The front left channel board was fried.  Since some of the transistors that needed to be replaced could not be identically sourced, I had them replace the same transistors on both the left and right front channel.  They repaired the power amp board and removed and replaced old glue on both boards.  Adjusted bias in both channels, cleaned all controls and bench tested for 16 hrs.  Hooking it up today. super happy to get it back. listening to movies via TV speakers is horrible 

Well .. everything sounds amazing ... after such a long time without a proper audio setup, it was so nice to watch a movie last night and play some music today

The repair lasted just over one year. Lost the left front channel yesterday so it is time to shop for something else. Not willing to spend another $1k and have to listen to movies thru the tv speakers for 40 days.
might also upgrade my 7 year old Marantz pre-amp

Sorry to hear of your problem. Would it be possible to purchase a 2 channel amplifier and use the Rotel for the center and surround speakers adjusting output levels from the A/V preamp?