Every 'Noll part has under gone re-inspection, cleaning & polishing. The painting work of "Fine Finishes" is truly dazzeling. Todate, I'm re-assembeling the table for now (less-tonearm) until I merge the Music Hall stand alone Turntable Motor Unit and the Table. The Platter looks stunning, but what is more important, Robb took it upon himself to flywheel balance the platter. It runs perfectly round.
Earlier, I "eyeballed" placement of the motor unit from pic's on AG ,I'm close ; only a "fraction" or so adjustment to equall the height of the Table , Motor Unit w/ VPI controller before speed tests.
My A+ gear is in Eric's shop for inspection and A/C balance . Tube replacement for the SP-10 & perhaps the input tubles for the S.O.B's. The 6550A are robust and are not up for replacement. My Audio room is up for a revamp. Lots going on to complement the 'Noll. Then picture time of the completed project. I will post the "Fine Finishes" work by Robb Shortly.
Earlier, I "eyeballed" placement of the motor unit from pic's on AG ,I'm close ; only a "fraction" or so adjustment to equall the height of the Table , Motor Unit w/ VPI controller before speed tests.
My A+ gear is in Eric's shop for inspection and A/C balance . Tube replacement for the SP-10 & perhaps the input tubles for the S.O.B's. The 6550A are robust and are not up for replacement. My Audio room is up for a revamp. Lots going on to complement the 'Noll. Then picture time of the completed project. I will post the "Fine Finishes" work by Robb Shortly.