Thanks. If you would be willing to share some details around your motor isolation, i would appreciate it. Since i have a table that is working pretty good, I do want to take this time to modify the signature to capture some of the ideas that have been discussed on this thread. Your motor isolation is one that has not gotten discussed much but seems to be a great modification. I will have to set up an air system with this table but a lot of that is already discussed earlier in the thread.
New Maplenoll Ariadne owner needing advice
I have recently purchased a maplenoll ariadne. I have tried to learn a little about the table but find very little information. I know the table was discontinued in the 90's but the little i have found indicated it is a very good table. I am interested to learn if there are any tricks or problems to optimizing this table. As most of you probably know, it is an air bearing platter and tonearm. I plan on putting my zxy airy 3 on the arm once I get it set up.
- ...
- 327 posts total
- 327 posts total