Night and day speaker connection


I made a great move since I have had always my speaker connected my speakers in BiWire configuration with Biwire speaker cable.  So,  I connect the two red speaker wire to the (+) to the "bass speaker binding post" via a banana plug. I did the same with the two black speaker wire to the (-) "bass speaker binding post" via a banana plug. The result is realy astonishing ! I would never go back to biwire connetions.  But you must use a good quality jumper, to link the two black speaker binding post together and the two red speaker binding post together . I can not stop listening now... to my new reveal music collection.


audiosens
I Tri-wire my ushers. I have a single speaker wire coming from the amp to the bass module. I then use a biwire speaker cable from another set of binding posts on the amp that hooks up the midrange and tweeter. My old setup was using the same single wire to the bass module then using a single 3’ Synergistics Research wire from the bass module to the midrange input then using a 8” jumper from the midrange to the tweeter.
My current tri-wire setup is much more simple and sounds better.
twolwftears,  Probably it would be difficult to make and find banana or fork connectors that accept such a big awg cable ?
Two biwired speaker cable together:
2 x 15 AWG x 2 = ? AWG
If your speaker binding posts accept spade and banana, you could one of each on the terminations.
The only technical explanation for bi wire is someone want to make more money selling you wire. Bi amping is another situation all together.
The obvious counter-argument is that wire doesn’t cost anything. Hel-loo!