Try them without the included rubber pads too. Try them under component base not under existing feet. I’ve only used them on tube amps (and turntables) so can’t speak for solid state.
Nobsound springs - load range
I want to try out the Nobsound springs as damping footers (mainly under my mono blocks and my streamer). I ordered a first set of them and now I wonder about the amount of springs to put in for different weights of equipment.I remember one post that said it works best when 50% compressed (was it @millercarbon?).
I measured the compression of the springs, it takes ~2.5 kg per spring to compress it to 50%. Based on 50% compression target, this yields the following sweet spot configurations (only stable ones, total equipment weight):
- 3 units, 3 springs each: 22.5 kg
- 4 units, 3 springs each (or 3 units, 4 springs each): 30 kg - 4 units, 4 springs each: 40 kg
- 3 units, 6 springs each: 45 kg
- 3 units, 7 springs each: 52.5 kg
- 4 units, 6 springs each: 60 kg
- 4 units, 7 springs each: 70 kgLoad can be considerably higher than expected (somewhere I read about 36kg, which is presumably for 4 units).
Any comments?What about ~10 kg streamer, seems to be too light to compress the springs enough? Does anyone have experience with Nobsound springs under light equipment like this?
Based on your experiences: Would you even dare to put an 80kg floor standing speaker on Nobsound springs?
I measured the compression of the springs, it takes ~2.5 kg per spring to compress it to 50%. Based on 50% compression target, this yields the following sweet spot configurations (only stable ones, total equipment weight):
- 3 units, 3 springs each: 22.5 kg
- 4 units, 3 springs each (or 3 units, 4 springs each): 30 kg - 4 units, 4 springs each: 40 kg
- 3 units, 6 springs each: 45 kg
- 3 units, 7 springs each: 52.5 kg
- 4 units, 6 springs each: 60 kg
- 4 units, 7 springs each: 70 kgLoad can be considerably higher than expected (somewhere I read about 36kg, which is presumably for 4 units).
Any comments?What about ~10 kg streamer, seems to be too light to compress the springs enough? Does anyone have experience with Nobsound springs under light equipment like this?
Based on your experiences: Would you even dare to put an 80kg floor standing speaker on Nobsound springs?
- ...
- 122 posts total
@ryder The Townshend pods rotate to change height for leveling. |
I don't have the Townshend pods, but I have the podiums under my heavy floorstanding speakers. They use pods on all four sides that are fixed to the podium and that have a knob to adjust the preload on the springs (in a certain range, there are different pod types for coarse load adjustment). With my speakers the Townshend podiums were a huge improvement, by some factor more than with the Nobsound springs under the components. The Townshend pods are much enhanced, as they are also rather free in the horizontal directions (Nobsound is more or less stiff there), and the Pods are also dampened in a controlled way. |
| Post removed |
- 122 posts total