2. amps-preamps
  3. 138839-16942

On the fence about Vinyl need a good phono stage for A/B testing

Got myself Rega P6, but humm I am not so sure if I want to listen to Vinyl over lossless audio. I have SET tube amp and thinking if I have to get tube phono stage or a good SS will suffice. The speakers will be Legacy Aeris. 

I am thinking ti try out Project Tube Box DS2 but guessing if I should I go all out with Luxman EQ-500 or be rational and settle for Parasound JC3+.

The signal chain will be Rega P6 with Ortofon Bronze -> Phono Stage -> Legacy Wavelet processor -> Line Magnetic 508ia -> Legacy Aeris.

Any advice is helpful.

thanks
geek101
geek101 OP
284 posts
 
Seems like Luxman CL-38u is a good deal and priced lower, what will I be missing when compared to EQ-500?. Do I really need all the bells and whistles?. Or there are fundamental difference in design in the phono input and output stages between these two?. I am a bit skeptical if I can notice audible difference between these two.
jperry
2,448 posts
 
There is more adjustability in loading which will make an audible difference. Whether you hear it is a question I cannot answer. The Luxman CL-38Uc is a preamp with a phono preamp built in not a stand alone phono preamp.
geek101 OP
284 posts
 
jperry, lol thanks, What is this "adjustability in loading". Where do I learn more about this, how can I google it. Does  "Herron VTPH-2A" have this?. I don't see no knobs anywhere. This analogue stuff seem like more work!!, but fun!!.
jperry
2,448 posts
 
 Both allow you to adjust loading impedance for moving coil cartridges. The Luxman Phono Preamp has a knob/wheel in the front. The Herron uses RCA plugs inserted in the rear of the unit.

The comments re: pF loading is applicable to MM cartridges only

From the Luxman website:
“Optimizing the cartridge load adjustment

The EQ-500 features a load capacity selection function from which 6 levels (0/50/100/150/200/300pF) can be selected according to the characteristics of the cartridge to be used. Com bined with the load impedance selection function (30k to 100k ohms continuously variable) the original potential of the cartridge can be fully exploited”


geek101 OP
284 posts
 
Ortofon 2M Bronze says "Recommended load capacitance - 150-300 pF" which means I have to select 150/300pF on Luxman?. I only see one set of inputs for MM on the back of Herron.
More to discover