This makes sense. Different designs do act differently when subjected to RFI.
Pass XP-17 and Hana ML loading question
Guys anyone here has any experience with the Pass XP-17 settings for Hana ML?
I just switched form Pass XP-15 to 17 and its totally different animal.
Just to compare them both with the gain set at 66db and loading 333ohm they act completely different, while 15 gets maximum bottom and fantastic detail 17 sounds great at the top and the midrange but bottom needs improvement. Would anyone run 47K ohm?
- ...
- 71 posts total
@laginz well with 47K fixed load you might be SOL, I've tried to push it as hard as I can and on my pre amps Pass XP15 and XP17 ML wouldn't take more than 440 Ohm on XP15 and maximum 1K Ohm on XP17. I tried 47k but it wont take it no matter what I do. |
SSG, I think we established that your experience with loading your MC at 47K ohms, namely that it sounds BAD, is so unusual as to be considered "unique". So I would not warn others against loading at 47K ohms. John Curl and Audible Illusions knew what they were doing. 47K ohms should work just fine. Lower R loads work fine too and are subtly different from SQ at 47K ohms, in all my 40 years of experience. Therefore it is also legit to find that you prefer a lower resistance load; many others do. Laginz, you are most assuredly not "SOL". |
- 71 posts total