Phase switch on pre amp use?

It is fine to play with it and is meant to be experimented with, on Classical sometimes it may be desired....thats my experience, many times you cant really hear a change. In short it is nothing to be scared about.

Where does it reverse the polarity? To the amp, speakers, all around...? What is this supposed to do, change sound or are some systems positive ground?
(Noided is slang for super paranoid)
Thanks again, John

The polarity is switched internally in the preamp. Some amplifier circuits invert the polarity 180 degrees while others do not invert. In an "op-amp", which is an IC chip used in some electronics - it has both an inverting and non-inverting input. There may be a slight improvement in sound by switching the phase. Try a listen both ways.

Another analogy of phase is your speakers. If the left and right speakers are hooked up out of phase, this will make a big difference in the sound. BUT on you preamp phase switch you are inverting BOTH channels at once - like if you switched Positive and negative on BOTH speakers.

It inverts the polarity of the signal output to your amp 180 degrees. So anything that follows would be out of phase from the original source. My cdp has a phase switch and I can't say it makes a difference although I've never listened critically for it. It certainly won't hurt anything. Why do you think they would put a switch that would cause harm so readily accessible?

I just bought a preamp (Aesthetix Calypso) in large part because it has such a switch and I was tired of switching speaker cables to change the polarity. You won't hear much if any difference unless your speakers are polarity-coherent (many aren't) and have no or very minimal crossovers. Even then, many discs were recorded in mixed polarity and defy anyone to hear a difference.

Bottom line: As Kal says, don't sweat it. But once you do begin to recognize polarity differences, you can't NOT hear them. Or I can't anyway. Best to leave well enough alone. Good luck, Dave