@atmasphere You are my AES48 hero (save me $$$) and I have been including that feature as an essential requirement when I look into the preamp - amp interface. With my limited experience with Benchmark gear, which support AES48, I tend to agree with your statements about the XLR interconnects. I just did not understand why my Benchmark observations were that way until you explained AES48 in some other threads.
I am not sure if a tube preamp would work well with the Yamaha NS 5000 speaker. I am also not sure if I would get the benefit of super low noise floor of the Benchmark AHB2 with a tube preamp. The Yamaha system will already be a softer sound with the Luxman and the KEF LS50 will be very detailed with the Benchmark. This is my intention to have 2 flavors of sound in my room. I will read up on these 2 atmasphere preamp units though.
So far the W4S preamp jumps at me as being in the same vein as the Benchmark and Mola Mola Makua in design, "straight wire with gain". Though the W4S is supposed to only add gain after pot 64 in the volume control, not sure what that means. I have posted a question to W4S on Facebook about support for AES48. If they respond I will post the answer here.
I am not sure if a tube preamp would work well with the Yamaha NS 5000 speaker. I am also not sure if I would get the benefit of super low noise floor of the Benchmark AHB2 with a tube preamp. The Yamaha system will already be a softer sound with the Luxman and the KEF LS50 will be very detailed with the Benchmark. This is my intention to have 2 flavors of sound in my room. I will read up on these 2 atmasphere preamp units though.
So far the W4S preamp jumps at me as being in the same vein as the Benchmark and Mola Mola Makua in design, "straight wire with gain". Though the W4S is supposed to only add gain after pot 64 in the volume control, not sure what that means. I have posted a question to W4S on Facebook about support for AES48. If they respond I will post the answer here.