PS Audio for Home-Theater


When I use the PerfectWave PS Audio P10 Powerplant to listen to music, it works fine. But when I use it for Home-Theater, it shuts down suddently after 1h of use! For the home-theater setup I use a 4K Optoma UHZ-65 projector, an Accurus ACT-4 processor, 5 Luxman amps (two M-900u for the frontal speakers, one M117 for the central speaker, one M-177 for the rear speakers, and one M-115 for the lateral speakers). I took care to connect the amps to the High Current inputs of the P10. Any clues and suggestions? Thanks!
128x128portoalegre
Five amps plug a projector into any power re-generator would be way too much, even for P10.  You -might- get away with two amps, but that's still a heck of a lot of current.
Hi guys, thank you for your prompt responses! Yes, I’ve added up and it’s way more than 1500W ... Thanks!!
Have you added up the power you are using? The P10 is rated for 1,500 watts.

The Luxman's at idle are 280W each, up to 540 at maximum. So, even at idle, there is more than half of your capacity taken (840W).

Do the rest of the math yourself. :)

Best,
E