2. analog
  3. 174943-3441

Remove Radio Station Background Noise

What is the best way to remove radio station sound from the TT feed to the pre amp? 

When I turn the volume up to about 50% I can hear radio station noise if my ear is next to the speaker.

I started using clamp-on ferrite chokes that clip around the cables from the TT to the phono preamp to eliminate the noise.  I wanted to know if there is a better solution or if the ferrite chokes compromise the sound.

 

The TT is a VPI Classic 3. The phono preamp is a Sutherland PhonoBlock and the pre amp (DMC-30SV) and amps (DMA-400) are Spectral Audio.  All cables are MIT Oracle MA-X. 

bigby
fuzztone's avatar
fuzztone
5,624 posts
 

Sounds like a LOMC to me.

bobsdevices
100 posts
 

Yes, you need EFI/RFI shielded cables.  2 twisted internal conductors covered by a shield (an aluminum foil covering then braided wire over the aluminum). Connect the shield to the - side of the RCA at the source end only and leave the other end disconnected.

vinylvin
146 posts
 

Try cleaning your RCAs.

bobsdevices
100 posts
 

There are some inexpensive cables on Amazon that will work well:

Made with Canare L-4E6S, Star Quad, Audio Interconnect Cable and Amphenol ACPR Gold RCA Connectors – Directional Design - Custom Made by WORLDS BEST CABLES

fuzztone's avatar
fuzztone
5,624 posts
 

Just slide some battery strappinh over what you have now and ground it to the closest amp.

More to discover