stereo5, Your SCD777ES may be very repairable. The one I repaired required some work on Gear C in the transport assembly. It would not spin on the shaft which caused the read problem. I used a fine 3 mm round file to open up the bore hole. As I understand, the nylon gears over time become too tight and friction on the shaft causes problems. I also purchased a brass gear on eBay from seller igorek50 for future replacement. It tested fine after bit of filing on the bore hole.
Dgarretson post was very helpful on how to remove the transport assy for the diagnostic.
Dgarretson post was very helpful on how to remove the transport assy for the diagnostic.