Replacing internal wiring.


For all those people spending big bucks on speakers cables , ever check into replacing the internal wiring in speakers or the amps?

Most but not all have cheap wiring inside, and does not even compare to whats on the outside, I was thinking about rewiring my speakers, with some kimber or audioquest using WBT solder thoughout.

Also doing the same operation on the amps, inside the amp is just a matter of replaceing some 12" jumper spades that would be super easy compared to the speaker over haul.

Let me know what you think
infwgf
Sol322, i have a pretty good idea of how to solder and would venture to say that i've performed well in excess of 100,000 solder joints in the last few years. Even with all of the past experience that i have and trying to "clean and prep" the surface, i could not get silver bearing solder to bond some joints on two mating surfaces. I even went so far as to grind the surface clean and "rough it up" so that the solder could fill in the crevices, applied rosin, used a small propane torch to pre-heat the surface, etc... with no luck. I also watched as two others that are skilled electronics professionals tried to make the same connection with no luck. Maybe it was funky solder, i don't know. Either way, all three of us gave up. Sean
>
Sean obviously you are very experienced soldering. My comment was aimed to the broad base of readers that read the forums for them not to get the idea of just put together heat and presto you got it, skill, practice and knowledge are required all of which you have
Cheers
I have found by using the same cable design inside my system components as well as the cables that feed them has made my system effortless and of one signature.No more hodge podge.All the same.The new copper based solder I ran across seems to have helped as well. No lead.-- Tom
Tom, what brand of solder is that ? I know that Cardas has a copper element to it, but it is surely not a high enough level to call it copper based. Care to share your "secret" with us ? Sean
>
The solder is named after its composition designer.Riehl Copper Solder.I used Brents hook up wire as well.Its a solid core with his micro-bearing shield around the insulator.This cable is naturally detailed and every so dynamic.1-877-668-4332. These products are from artists who think outside the box. Enjoy, Tom