Revel salon 2 break-in period?

Every speaker I’ve own from new sounded substantially better after a considerable breakin period. Depending on the speaker breakin period could go from 100-500 hrs.
As to The mention of DR. Sean Olive perspective regarding speaker breakin I don’t put a lot merit into ones belief that if you can’t measure it doesn’t exist or it’s only something that ones imagination is telling himself it does.
All wire, capacitors, resistors, drivers all exhibit substantial changes after they have been used over a period of time, how long depends on type used.
Why do I make this claim? Because I’ve heard it take place with every new product I’ve owned!!!

Hookay....if you believe you know better than a renowned expert in speakers/acoustics/listener perception, and whose careful scientific work formed the basis for the very speaker you own...so be it.  (The very reason you like your speakers so much essentially IS because someone like Olive really knew what he was talking about).

Once one encounters the "I heard it, so it’s true" response, the road seems to end there.


Just tryin’ to possibly save you some audiophile angst. ;-)

It depends on the design and manufacture of the speaker. A good design and well built won’t need break in. It should break in within a minute or two perhaps an hour at most.

The air suspension and voice coil motor should dominate the woofer response and not the spider or rubber surround compliance.

Tweeter motor should dominate the tweeter.

If the response drifts over hundreds of hours then the speaker response is dominated by minor factors like spider and surround compliance. It suggests a weak drive motor and a lack of air suspension relative to everything else. It suggests that the speaker will not be very linear in response. Open baffle speaker woofers are the most likely to need break in.

just play them non stop for 4 days at moderate volume. youll then know for sure how they are supposed to sound