Something strange with imaging
Hello all,
I am using a Kuzma Stabi S turntable with Stogi tonearm and Soundsmith modified Sumiko Blackbird. I have 2 preamps I use for the player. An EAR 864 and a Parasound JC3/JC2 combo. I don't play vinyl often. Something strange has been happening lately. The image has been pulling to the left. It happens with both pre-amps. First thought was the cables from the player. I switched the right to left an left to right. Low and behold , the imaging was spot on, albeit reversed. This occurs with both pre-amps. Could it be a stylus azimuth or VTA issue? Any thoughts?
- ...
- 15 posts total
Hard to say. I had a similar sounding case recently where I found a particular phono preamp setup I was using to convert to digital had a small hardly audible but measurable difference in output levels left to right. It was simply a minor flaw that may have developed with the device over time. I went to a different setup recently but with same cart and step up transformer, and now things measure equal left and right as they should. So ideally it’s just a poor connection or combo of connections perhaps but always possible any device involved in signal path from the cartridge on could just be off somewhat left versus right. I’ve seen it happen on multiple occasions over the years with phono cartridges in particular. It’s also possible more than one device in the chain has some l-r output level difference and they cancel each other one way and augment each other to be heard the other. |
Image position follows the tweeter, as I found out when one of mine failed. You’ve established that the issue is somewhere before the phonostage, a dameged cable with a higher capacitance on one channel might be involved but I think it a long shot. What happens if you swap channels at the cartridge tags and the phonostage input?
Try another cartridge.
How are you setting bias? If you do end up sending the blackbird back to Soundsmith get them to assess the wear on the stylus and condition of the suspension. This can tell you if you’re getting it close enough.
|
@yeti42 : When the OP revered the cables everything is ok, so I don't think the cartridge could have a problem with stylus/suspension because if it had then in both situations the OP was hearing the same but in the other channel.
R. |
- 15 posts total