Speaker placement behind the screen


We are a small independent movie theater with 100 seats. Our speakers are located behind the screen.  We often get complaints that the dialogue is too low.  Two questions: 1)  What is the optimal height for the speakers?   We've been told that they are too low (currently about 3 ft off the floor).  2)  Can we change the mix so that dialogue is louder without making music, sound effects, etc. louder?  Our head projectionist says no.

Any suggestions for references I can go to?  Thank you!

128x128carolm7
It is hard to tell without speaking to the OP, as some one who has worked in motion picture sound I have some thoughts:

Take care of the basics
  • Horns are positioned facing the middle of the audience, not the back wall and ceiling.
  • Measure your speakers at multiple locations and apply corrective EQ as needed.
  • Control resonances to modern standards.
  • Minimize or eliminate noise such as A/C units, outside sounds.
  • Ensure all 3 speakers are operating optimally. Horns and woofers are both producing correct output.
  • Ensure your overall speaker levels are properly calibrated.
Now the next part will seem counter intuitive to audiophiles, and I'm sure there will be uninformed arguments:

  • Some movies such as LoTR are produced with excessive dynamic range. To hear the softest voices requires too high a volume, which you then suffer through far too loud effects.
The solution is to limit the dynamic range. I'm not sure what pro sound processors now use, but investigate and enable any compression that is available to you. If you can't find it via the Dolby/Datasat settings, an audio compressor on the center channel may be what is needed. Available through many recording gear outlets.

The compressor will work to raise the level of the softest sounds, while leaving audible levels alone.


Thanks to everyone who responded.  Getting closer to a solution, and will probably contact a sound tech at the local commercial cinema.