Speaker Spike Help

Using @millercarbon 's BDR cone recommendation as an example...

They measure 1 inch high. My max is 7/8th of an inch.

They measure 1.62 inches wide. My max is 1 inch.

@david_ten .
I am a little confused by your post.

B. What do you recommend for securely attaching a flat top spike (the Hemi-Spike has a 1 inch / ~25 mm diameter) to the speaker cabinet bottom?

Do you mean there are no threads at the bottom of the speaker?
B

They measure 1.62 inches wide. My max is 1 inch.

Remember they don't have to go the same place. They can be used anywhere flat so long as they are far enough apart to maintain stability.

Also as far as height goes there are tables you can look up on-line for free to study the effect of port size/length/diameter. Basically what happens is raising the speaker higher reduces restriction of air through the port, which has the same effect as increasing the length or decreasing the diameter of the port. Play around with a calculator you will see real quick what this means. Sitting the speaker flat on the floor will effectively plug the port and make your speaker into a sealed design. The high mid-bass output and fast low bass roll off of the port will become the flat mid-bass output and more gradual low bass roll off of a sealed cab.

If you do this it will in no time be clear that unless you go way high or way low whatever difference you make will be at most about the same as what already changes anyway just with normal speaker placement moves, and probably a good deal less. 

@gdnrbob  My apologies. Hopefully this post will clarify. If it doesn't, let me know.

The front of the speakers have M6 inserts and come with stock spikes and floor protectors.  The rear of the speaker has two 'rubber bumpers' with metal cores, attached via a phillips screw. 

To attach a 'standard' spike with threads (For The REAR), I will need to drill two insert holes and install the threaded inserts. 

Due to the finish of the cabinet, I'll need to use a special bit as well as be very careful so I don't damage the finish. Further, there isn't much room for error in terms of the surface and width and material available for drilling / to drill through. Obviously, I will need to also be careful with the 'hole' angle and the need to match both.

I went with a flat / smooth top for the rear 'spike' to avoid the above. Not ideal, but if it gets me most of the way there... :)

Luckily, the front is setup for easy swapping of spikes, etc.

Can you use a 1" aluminum bar mount across the rear end of your speaker using the existing phillips screw holes and put those spikes as outriggers?  

https://elac-content.s3.amazonaws.com/uploads/2016/01/Uni-Fi-Foot-Web.1349-1500x712.jpg