Well, it's pretty obvious the springs for the Linn are the wrong springs. Because if they were the right springs the turntable would not be affected by footfalls. There is a very simple relationship between resonant frequency, mass and spring rate. Most likely the folks at Linn didn't get the memo.
Suspensions on turntable...really effective?
Been wondering about this, so did some research, but was surprised I couldn't find any that categorically says that turntable suspensions really isolate/substantially reduce outside vibrations, resonances, etc.
Any reference out there you can point out?
Cheers
Any reference out there you can point out?
Cheers
- ...
- 57 posts total
- 57 posts total