2. amps-preamps
  3. 1448317474

Synergistic Red Fuse ...

I installed a SR RED Quantum fuse in my ARC REF-3 preamp a few days ago, replacing an older high end fuse. Uhh ... for a hundred bucks, this little baby is well worth the cost. There was an immediate improvement upon installation, but now that its broken in (yes, no kidding), its quite remarkable. A tightening of the focus, a more solid image, and most important of all for my tastes, a deeper appreciation for the organic sound of the instruments. Damn! ... cellos sound great! Much improved attack on pianos. More humanistic on vocals. Bowed bass goes down forever. Next move? .... I'm doing the entire system with these fuses. One at a time though just to gauge the improvement in each piece of equipment. The REF-75se comes next. I'll report the results as the progression takes place. Stay tuned ...

Any comments from anyone else who has tried these fuses?
128x128oregonpapa
kalali's avatar
kalali
1,977 posts
 

64 pages... this must be a record...I (obviously) haven't read every single post on every single page, but has anyone asked why not ALL manufacturers use these fuses in their components if they make their units sound better? If it were me, I would definitely signed a volume purchase contract with SR just to get some advantage over my competition. Sounds stupid?

ps
746 posts
 
Spending too much is never enough.
oregonpapa's avatar
oregonpapa OP
4,867 posts
 
^^^  
Let's say it costs $2500 to manfacture an amp. The factory sells it to the dealer for $5000. The dealer then sells it at retail for $10,000. 

If you were the manufacturer, you would have to double the price of the fuse to the dealer and, the dealer in turn, would have to double the price of the fuse when selling the piece of equipment to the end consumer.


Now then, in the case of the high end fuse: The factory buys the fuse for $50.00 ... 50% of retail.  The factory increases the price to the dealer by $100.  The dealer then turns around an sells the piece of equipment marked up by another $200 to cover the new fuse.  

As an end consumer, I would rather pay retail of $100 for the after market fuse than pay $200 for it placed in my new piece of equipment for me at the factory. 
ptss
1,964 posts
 
oregonpapa is smokin some more of his "special blend"--probably
the most valuable component in his listening arsenal.
And the poster trying to say 2 manufacturers recommended these junk
fuses has backed off promptly when asked for clarification.
Again, it's shameful that some unconscionable types, charlatans,snake oil salesman
continue pushing bull shite
dlcockrum's avatar
dlcockrum
2,190 posts
 
Keep pushing guys, he's about to snap. lol

Dave
More to discover