System Static Issue

Did you clean all connections,or just move them?  If you didn’t clean them,that’s where I would start. 
   

Tomorrow morning just turn on the Bedini Amp. Do not turn on the preamp for a while. Listen for the static noise. If you hear static it's not the preamp causing it.

.

Disconnect the network.  Then try just amp, then amp+pre-amp.  Then reconnect network.

jea, good thought, can start them up one at a time

nevada, will start up eachone at a time, network is connected to DAC, so I can kill that.

Forgot to mention I have a bluetooth receiver to stream from computer to pre.

As pre is muted until it warms up, I have a little difficulty thinking it is tubes, but submitted question to ARC support....just in case

Ordering Deoxit to clean contacts..

My Bedini 100/100 has started to make a thump on startup. It’s not a static sound so I’m not saying it’s the problem you are having or that it’s the amp. I am saying mine is getting old and I know it needs updating. I’ll be interested to see your findings. 

Start up the ARC preamp first, wait until it get out of mute after its start up cycle completes, put it in mute manually, then power on your amp. Power on order - source, preamp then amp. Power off order - amp, preamp, source. 
As to your problem, most likely tune(s) in the ARC preamp need to be replaced. So it’s important to follow the power on and power off order. 
 

Ok, so for today I started the amp first and nothing but dead silence. Now ill turn that off and start preamp as audphile1 suggested, qallow it to warm up and take it out of mute and put back in manually and see what happens

Okay, apparently it has something to do with the pre as turning amp on after the pre has warmed up there was no noise (static sounds) coming from system. I guess tubes will be the first order of business...

Thanks for the suggestion guys, mystery solved

On average small signal tubes in ARC equipment lasts about 5000 + hrs.

The static could be caused by dirty tube socket/tube pins contact. You might try pulling and reinserting each tube a few times one tube at time in each socket. Usually that will clean the pins and socket contacts.

Good thought, have to check at home and see what tubes I have for the 28 & 5se, retubed them within recent memory just due to age rather than hours. They were fine when pulled.

Wish the 17se had a hour meter like the others....

Good to hear you isolated it to the pre. Like I stated in my response earlier, always turn the amp on last. I would fix this issue though ASAP as it can, if you allow it to get worse, potentially take out your amp or your speakers or both. Good plan to start with a fresh set of tubes.