2. amps-preamps
  3. 184343-67361

System Static Issue

Have an interesting situation in my system that I have at my work location. The system is leftovers from other upgrades but since it is used primarily as background it fullfills that quite well.

Recently, when I start it up in the mornings, while the preamp is in mute mode and volume is at 0, with no input signal, I will get a static sound out of both speakers, intermittent, but there.

I am assuming it is the tubes in pre (ARC LS17 se)

Have checked all connections and moved each (without static) to make sure that was not the problem.

Set up is used either to stream from internet or through a PSA Jr from SSD with music library on, through JRiver.

Before I get new tubes wanted to see if there are other issues I should consider.

ARC LS17se

Bedini 100/100

PSA DSD DAC Jr

Shahinian Arc

Furman Power PL Plus

128x128stevea1298
jea48
4,451 posts
 

On average small signal tubes in ARC equipment lasts about 5000 + hrs.

The static could be caused by dirty tube socket/tube pins contact. You might try pulling and reinserting each tube a few times one tube at time in each socket. Usually that will clean the pins and socket contacts.

stevea1298's avatar
stevea1298 OP
48 posts
 

Good thought, have to check at home and see what tubes I have for the 28 & 5se, retubed them within recent memory just due to age rather than hours. They were fine when pulled.

Wish the 17se had a hour meter like the others....

audphile1's avatar
audphile1
5,177 posts
 

Good to hear you isolated it to the pre. Like I stated in my response earlier, always turn the amp on last. I would fix this issue though ASAP as it can, if you allow it to get worse, potentially take out your amp or your speakers or both. Good plan to start with a fresh set of tubes. 

More to discover