Tactile bass shaker lp/hp settings

I have a dsp that allows me to set my shaker https://9apps.ooo/s fairly exactly. I’m looking for just the big boom and bangs not the music and voices. It’s currently set HP 24db freq 22hz / LP 48db Freq 38hz. n Is that where it should be?

issue got solved

I have a dsp that allows me to set my shakers fairly exactly. I’m looking for just the big boom and bangs not the music and voices. It’s currently set HP 24db freq 22hz / LP 48db Freq 38hz. Is that where it should be?

Thanks 10.0.0.0.1

issue got solved

I have actually used these back in 1998.  I had 6 of them bolted to the bottom of my couch.  It did create additional bass vibrations that you could feel, but after experiencing them, they really did not add that much to the movie experience.  Kind of a gimmic in my opinion, but go ahead and try them.  Probably set the crossover to 70-80hz or something.

Mount them on Nobsound springs.  Transformational!

The same reason people buy cables, goop for cables and fuses.

To see if it makes an improvement. 

And why would anyone want something that outrageous and cheap in their high end system?

What in Gods name is a bass shaker?

Here ya go. I even put the link there so you could buy a couple of them
https://www.amazon.com/AuraSound-AST-2B-4-Shaker-Tactile-Transducer/dp/B0002ZPTBI/ref=sr_1_1?dchild=...

The Bass Shaker products allow you to experience every thump, thrust and shake...the way bass sound was originally intended. Mount the bass shaker firmly onto the object or furniture you want to vibrate. It must be mounted to something solid, like wood. The bass shaker produces a vibration at about 40Hz. Wire two together in series for an 8 ohm load or use a single at 4 ohm. Does not require a crossover. Only a 50 to 100 watt amplifier is needed to power it. Higher wattage is okay of course. Connecting two in parallel is a 2 ohm load, too low for most amplifiers. Here is how you add bass shakers to your home theater system: 1) Find the variable low-level RCA output for the subwoofer (LFE) channel on the rear panel of your AV receiver and disconnect the cable going to your powered subwoofer. 2) Connect a RCA Y-cable to the subwoofer output on your receiver. 3) Connect the cable from your subwoofer to one end of the Y-cable. 4) Connect a cable to the remaining unused end of the Y-cable to an input on the amplifier being used to power the shakers. 5) Connect the shakers to the output of the amplifier. 6) Set the relative level of the shakers by adjusting the volume control on the amplifier driving them.

They also opposed marriage and were major proponents of celibacy.

<<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>

Man oh man, all around party poopers..

I thought the Shaker philosophy was honesty, utility and simplicity?

What in Gods name is a bass shaker?  Another word for subwoofer?