Technics SL 1200GR with What Cartridge???


I'm starting yet another thread on a similar topic, because I don't want to hi-jack someone else's thread, and I haven't found the answer to my question in other threads.

OK... I'm considering returning to vinyl for some of my listening and I need a Cliff's Notes version of what cartridges I might want to use.  

I've had a Linn Sondek LP12 for years, which I've barely used... but... it's been in storage.  As I recall it was pretty "finicky" and required a lot of attention to perform it's best (which was/is good).  I don't have enough patience anymore to deal with that, and am planning on moving to a Technics SL 1200GR, because it seems simple to operate, gets good reviews and doesn't seem to require a lot of attention. 

It appears that you can get great sound quality from the 1200GR with a good cartridge.  I'm just not sure what might be optimal / best for the money.

I also do not want to go crazy with esoteric cartridges that cost a mint.  My budget is probably in a range of... say... $300-400 to maybe $800-900 (if the cartridge is noticeably better than the more modestly priced cartridges).  

My Linn cartridge is a MM cartridge, I think (Basik or K9) in an Itok arm.  

That's about it.  

I'm not really interested in considering a lot of alternatives either in a turntable, or cartridges.  

Any guidance in this context would be appreciated.

bassdude

+2 for Nagaoka (MP-150 or higher)

I currently have a Tech 12010GR (1200 in black) and run a Nagaoka MP-200 with GREAT results. I think anything in the Nagaoka line works well with past and present 1200 tables....which is why the 1210GAE comes stock with a new model of Nagaoka cartridge.

I’m using a Ortofon Quintet Black S and A-T VM760SLC, both work well with the SL-1210GR. 

You know I recently saw Frank Shroeder observe that the “two best cartridges in the World” were the Denon 103R and the Audiotechnica AT95 – both inexpensive, practical cartridges. I listened to both on YouTube and in A:B comparisons, they each sounded about the same as cartridges costing many, many times more.

I listened to the A:B comparison between the Denon 103R to the expensive Lyra Delos and could hardly tell a difference between them.  It's a bit surprising how subtle the differences are between many cartridges, including some of the most expensive ones.

So... I'm going to start out with the Denon 103R, and maybe the AT95. I may never need to go any further. They both sound superb.

And... as a few have suggested, I will likely begin with setting up my Linn Sondek again and trying the Denon 103R, before "I plunge into deeper waters."

Post removed 

My 1200GR sees a Hana ML and a Denon 103R for stereo. For mono it’s Miyajima. For the price, the 103R is a great cartridge. I run it through a SUT - Bobs Devices 1:40. The math doesn’t work but the sound is incredible. I’ve done the 103R with a 1:10 SUT and it was OK but not as dynamic (after compensating for volume). All tube gear after that - Decware phono preamp and Tektron EVO w/ 45 mesh plates currently. 
 

I know your focus is stereo, but I find where the 1200 really shows it’s stuff is at 78rpm. It’s based on a transcription motor. IMO, if a table can do 78 well, everything else should be easy.