Thiel Owners

silvanik

Send Rob a note from the contact page of his website, that should get you a response. I’ve never waited more than a day to have a question answered or any other service.

https://www.coherentsourceservice.com/contact/

Ciao, Brett

silvanik

as above, contact Mr. Rob Gillum on his contact page via CSS site. Then, inform about attempting contact via rob@coherentsourceservice.com

He may/may not be aware that Rob email address is not operational?

Happy Listening!

I contacted Rob a few weeks ago through his website.  He responded quickly, using that email address.  It's quite possible that by emailing him directly your email may have been caught in his spam filter.

A while back Tom suggested trying to using brass fasteners .

I found the size  for my 2.7 speakers to be 8/32 by 1/2 inch for the coaxial and by 1 inch for the woofer and radiator .  The pan head srews fit perfectly in the woofer and radiator but were a little to large in diameter ( .6mm ) to fit into the coaxial .

After spending a lot of time looking for a 8/32 with a smaller head and being unsuccessful I had to grind down the head of the panhead screw .

For about $12 It was worth the effort .

And there was a positive sonic benefit correct? The sonics will also benefit with the removal of any steel screw to a  brass replacement. Any fastener holding or near the crossover or binding posts should be brass. Non ferrous materials sound better. Brass is the metal of music and I think sounds best.Tom D.