Tube Preamp vs Solid State

I've heard a "cheap" tube pre sound better than an expensive
SS pre many times.
Also have lost a pr of Rega RS-3 and a pair of KEF 105's to tube failure in a tube pre.

Thieliste Hi.

Before you try/buy waist money/time on anything, try this.

Your only source the Ayon S5 has a volume control, and it already has a highly regarded (by tube lovers) a low output impedance tube output stage which is a 6H30.
This is just like having a unity gain tube preamp, but with the extra gain that you don't need.
Because your 6h30 tube in the Ayon S5 gives out 2v at 700ohms and your Karan power amp only needs 2v for full output before it clips.
And the impedance match ratio from the Ayon output (700ohm) to your Karan input (33kohm) is a healthy 1:47 ratio, you have a great match to drive direct from Ayon to Karan, no need for anymore unneeded electronics in the signal path.

Cheers George

I am in GEorgelofi's camp these days and like to keep things simple. If you have enough gain, and a volume control, no need for any pre-amp other than as a potentially expensive (and inflexible) signal processor.

I am looking to try and dump all my active pre-amps at some point, probably when each finally gives up the goat. Maybe even next time I need a fresh set of tubes.

I use a BAT pre with a SS amp for my Thiel CS2.4's with good results, I would think you would also achieve the same especially if you want to "tame" any brightness at the top end.

Good Day Thieliste,

I,too, regard the Thiel Cs 3.7 as a true reference loudspeaker. I choose the CS 2.7 model, as my room is too small for the mighty 3.7-

Recently, I have read about BAT, VAC and VTL are being sonic matches w/ Thiel speakers.

Tell me about your cables/power cords that you plan on using?

Keep me posted- Thiel lover here!