2. amps-preamps
  3. 1358602075

Tubes going bad???

Do tubes “go bad” slowly? If so, how do you detect when they’re “going bad”?

Some years ago I had a lesser tube system than I have today and was not so critical in my listening. As I recall, there came the point where I obviously needed to re-tube, my system sounded awful.

Moving forward, I’ve stepped up significantly in my equipment (Conrad Johnson’s Premier 16LS and Premier 12 mono’s)+ other tube gear. With consideration of the pursuit of system optimization (upgrades, tweaks, placement, etc.), how do I know if my tubes are performing optimally - sounding as good as it possibly can? If tubes do degrade slowly they may only be 97% today, 95% next month, 92% a month or so later at which time it becomes apparent it’s time to re-tube. If this is the case, I’ll have gone through a period of less than optimal tube performance that I did not catch on to until it became very apparent.

So, do tubes go bad instantly or is it a slower process that needs monitoring?
rbschauman
rbschauman OP
138 posts
 
Thanks all for the responses. Having a spare set for evaluating the set in use is a great suggestion. This also alleviates ever being caught shorthhanded.
vhiner
544 posts
 
Conrad Johnson actually has a recommended tube replacement schedule for all of their gear. I have a CT5 and they recommend replacement of its 6H30p tubes every 1500 hours or so for best performance. My ears confirm this.
cellorover
426 posts
 
First, you have two very good pieces of equipment. The Premier 12 can be upgraded and further improved so you can keep it forever. Call CJ and they can walk you though the whole process include tube replacement. Tubes last longer than you think. The sound will get slugish as stated, but also can sound distorted and/or make noise. Remember! not all tubes amps are designed the same so not all tube amps respond to tube rolling the same way.
Post removed 
larryi
4,124 posts
 
How equipment will sound when tubes begin to show their age, depends on the way the equipment pushes the tube. If the tubes are run hard all the time, they will start to sound sluggish, muddy and lacking in dynamics much sooner. If they are run more gently, they can be quite weak and still sound pretty much the same as new. I have an amp that uses 6sn7s as drivers. These tubes can read extremely weak on my tube tester (Amplitrex) and still sound very good.

Also, if you tracked tube performance (e.g., transconductance) against time of use, you would find a broad plateau--over most of the tube's lifespan performance does not change much, but when they finally do start to decline, the decline is, comparatively speaking, much faster than the very slow decline during the plateau period.
More to discover