Grado MI cartridges are not sensitive to capacitance (associated normally with different phono cables / or if there is a capacitance switches on the phono stage), but load resistors is another story and the manufacturer gave you a range from 10k to 47k for this particular model, this is cartridge loading. The cartridge is MI, so what you see is different loading for MI, not for MC cartridges.
Tweaking the new Grado Timbre Sonata 3
I have about 10 hours on my new Grado Sonata 3.
relevant system:
VPI Prime > Sonata 3> ARC PH3se (phono pre) > Herron 1A (preamp) > ARC Classic 60 (amp) > Thiel CS 2.4’s (speakers)
My old cart was a Nagaoka MP 500. While good, the Grado is better overall. But the highs are a bit more extended than the Nagaoka, which seems to be a bit excessive, but just a bit, almost, but not quite sibilant.
Alignment was done with my trusty AS Smartractor, though difficult to use on the Grado due to the long wood body overhang on the Grado.
Raising and lowering VTA has little effect.
My question, before I get too worried about this prior to complete break in, is will the highs “soften” up once broke in. Is that typical with Grados? Or, is it I gots what I got.
relevant system:
VPI Prime > Sonata 3> ARC PH3se (phono pre) > Herron 1A (preamp) > ARC Classic 60 (amp) > Thiel CS 2.4’s (speakers)
My old cart was a Nagaoka MP 500. While good, the Grado is better overall. But the highs are a bit more extended than the Nagaoka, which seems to be a bit excessive, but just a bit, almost, but not quite sibilant.
Alignment was done with my trusty AS Smartractor, though difficult to use on the Grado due to the long wood body overhang on the Grado.
Raising and lowering VTA has little effect.
My question, before I get too worried about this prior to complete break in, is will the highs “soften” up once broke in. Is that typical with Grados? Or, is it I gots what I got.
- ...
- 20 posts total
- 20 posts total