two problems with turntable


First time poster here. First of all, thanks to the group for providing some insight as to problem solving as well as your experiences with various brands of audio gear. This sight, has been very informative over the years as well as entertaining at times.

My system:
TT-Acoustic Solid, White,(no longer in production but similar to other Acoustic Solid models), WTB 370 arm made by REGA, Ortofon Quintet, Red. This TT isn't common in US as they mainly sell in Europe, Asia and Canada
Gold Note PH 10
Innuos Zen MK3
Bryston BP17 cubed with DAC
Bryston 4B cubed
Vandersteen TREO CT
Vandersteen Sub 3 (2)
Cables IC-Audioquest Yukon, Speaker-Cardas, Power-Audioquest NRG Y3
Room treatments-GIK and Acoustimass panels

This system was put together over the past few years. All components worked perfectly very well until recently. About five months ago I broke the red lead wire on the tonearm which is the right side (+) and after the wire was replaced and sent back by a reputable dealer, I notice the left channel plays about 5-10 db lower than right channel. The dealer says that if I bring the entire TT back to the store, they will analyze completely but they're over an hour away. This problem only occurs with TT playback and not digital playback and has been this way about two months. The other issue I have is with anti skate. The recommended VTF is 2.1 to 2.5 and it's currently set at 2.28. The optimum setting I have found for anti skate is just above zero which seems odd because most set ups call for anti skate to be set similar with VTF. VTA and Azimuth settings appear to be spot on and the right channel plays perfect. Cartridge alignment was set up properly with the protractor provided. The Gold Note has two inputs and I've tried both inputs  with the same results. 

This forum has some extremely experienced and sharp minds and I hope that one or more of you can help me solve this issue.

Thanks,

George



george4471
Probably they replaced the broken clip with a new one and between the new clip and moving it on and off this connection is better now and this could be what accounts for your other channel being down in level. You can try removing the clip, cleaning with alcohol, and replace. If it slides on and off easily you might want to tighten. Place a round toothpick in the clip to avoid crushing and tighten cautiously. This is the most likely fix given what happened.  

Anti-skate is always set the way you did, by ear. I could write a book but all you really need to know is if it sounds right, it is right. 
That is a substantial volume difference George. I seriously doubt wiring would do that. Might be a bad cartridge or phone stage. If you have another cartridge give it a try. If not you probably would be best off taking the hour ride.
Step one: Reverse the left and right turntable leads at the input of your phono stage. If the left channel still plays at a lower level, you know that the problem is in the phono stage or amp, not the turntable or cartridge. I'd rule that out before fiddling with the cartridge or headshell.


@millercarbon- I will try your suggestion tomorrow  being very careful as I already know the clip and wire can be broken easily
@cleeds- I did reverse the turntable leads and encountered the same problem. Approximately 5-10 db less on left channel. Perhaps it is phono stage even though only two years old. Would you rule out the amp since this difference in volume  only occurs on TT playback?
Cleeds advice first, cardinal rule isolate to component first. Nice system, bet it sounds great :-) Treo CT are a treat.
some Rega arms use a DIN at base of arm, check to see if we’ll seated