Unplugging power cords from amps/ pre amps


This might be a stupid question but when there is a thunderstorm lightning storm I used to unplug my power cords from the outlet but now I can’t do that because of a lot of things in the way to reach my plugs from the outlets. I want to know if it is ok to unplug my amps / pre / cdp from the female end that goes to my equipment and then replugging them back after.  Of course the units are off when unplugging / plugging them back. Ty. 

128x128Ag insider logo xs@2xtattooedtrackman

Does anyone unplug all the electronics in their house...

My stereo is easily the most expensive and hardest to replace, so I naturally unplug it.  I also unplug my computers and welders, but they're just expensive.

Do you own your own home ? 
do you have a dedicated 20 amp. Line 

IHave several layers A Siemens home surge protector handles small as well as big surges at your breaker box.  VH Audio has a great surge protector with power factor correction. You put on your specific breaker.

if you have $$ there are dedicated Battery 🪫 systems you can play music a solid 8 hours or more .

Does the manufacturer specifically warn to unplug the power cord only at the receptacle and not at the equipment? 

Since the power cord detaches at the equipment, it is reasonable to assume that some end users would find it more convenient to plug/unplug at the equipment end. If that is a problem for some reason then a caution would be printed on the owners manual and the back of the equipment. Also, the equipment end is chamfered to fit the receptacle, preventing inadvertent polarity switching. All these signs point to it's okay to unplug everything from the equipment.

@OP There is no problem unplugging your equipment at the component end. Just  be absolutely sure to do it after turning off the relevant components.

The biggest risk in thunderstorms is to anything that's connected to an antenna like a radio aerial or satellite dish.

I have seen fires started by lightning strikes to such equipment.

I just blew out my Jeff Rowland Model 201 stereo amp power modules by plugging in the IEC into the amp when  the power cable was plugged in. 

Make sure the power is off to the power cable before plugging in the IEC to your amp.