2. analog
  3. 1390929980

VPI Scout 1.1 Motor Noise

I have read what I can regarding this. I have a Scout 1.1 and one day the motor was super quiet during 6 or so LPs - the very next day it was so loud I could hear it from my listening position, during quiet passages, and in between songs. I have had the table about 3 months. I think the motor is the 600RPM one. Table was bought new from Elusive disc - waiting to hear back from them as the VPI site says contact dealer first for problems. The table is great, tracks great and has little surface noise (Soundsmith Zephyr cart). I tried the one drop of Purple Racing oil (per VPI per another thread here.) No luck. It still makes a whirring noise as it did before the oil drop. I did notice when I turn the pulley manually, it does not turn effortlessly or glide so to speak. It seems like it has resistance every fraction of a turn (almost like a volume control that has "steps" in it. Does that sound normal?
moofoo
fivechannelguy
19 posts
 
I had the same problem with the motor of my Scoutmaster. I brought it to VPI. Harry discovered the plate at the top of the motor was loose. He unscrewed it, put a drop of glue under it, reattached it and it was quiet again.

Jon
moofoo OP
290 posts
 
Thank you all for your responses. I will try the mouse pad and yes the motor makes the same noise when it is away from the turntable. I will also check to see if it is rubbing against anything. I did hear back from Elusive Disc so hopefully I will get it worked out. Thanks again
riffer
362 posts
 
Just took a look at mine to see if there are any other possible issues. Other than making sure the set screws are adequately tightened, I can't think of anything. Elusive disk have good customer service, so hopefully this can be resolved.
moofoo OP
290 posts
 
Thanks Riffer. The set screws are tight.
moofoo OP
290 posts
 
For those that may have this issue with their VPI motors - I heard back from Elusive Disc who spoke to VPI and said it may be a loose pulley or spindle. I loosened the pulley hex screw and the spindle hex screw and slid both up and down a little, re-positioned each, then re-tightened each screw. The noise went away. All quiet again.
More to discover