Woofer sucking in and out

Hi Ct0517,

Thank you for your reply.

I did see that but I still feel the arm/cartride relationship needs to be examined again. Moving the TT probably only reduced the problem exhibited by that relationship.

The low freuency pumping of the woofers is probably not sourced from the speakers because it is much lower than their cutoff frequency. If it is sourced from some other source (like a large ac/heating system or a nearby industrial plant or highway) it can be verified by removing the belt from the platter and lowering the needle into the groove of a stationary record. If those are the source the pumping will be evident. The owner can also start the TT motor to see if that is the source coming up through the platter. If none of those are the source it is most likely an arm/cartridge mismatch or misalingnment.

Best,

Barry

Saw a number of typos in my reply but can't seem to find the edit control.

Tuning the resonant freq of cart/arm can damp some vibrations or at least reduce the excitability. It is part of the feedback loop. If the floor vibrates at higher frequency than the reson freq of the cart/arm, it will provide damping. If the floor freq is the same as the arm/cart reson frequency, the effect is amplified. If the floor freq is lower, the carm/cart tuning will not provide adequate damping. See Minus K article on transmissibility of vibration.

Some speakers have output below 20Hz. More so, while the floor will damp a lot of the higher audible frequencies, it may end up moving at a lower frequencies after being excited. Many of us feels the floor vibrates at heavy bass passages but we don't hear the floor playing bass.

Stuff happens go figure.