Your journey with lower-watt tube amps -- Can a kit be good enough?

Hi @hilde45 

The problem of 300B they need a driver with 150 volt peak to peak voltage swing. For 845 you need much more voltage swing.  

It is possible to drive 845 with RC coupling, but you get much more distortions vs IT drivers with the same tubes. With IT - the output tube can be driven when it is in class A2 and you get more power and better clipping recovery.

I have a DIY 300B amplifier and I used 6f6 in triode with RC coupling, then I changed to IT coupling. It was a huge difference! It sounded like a different amplifier. And I used super expensive V-Cap CuTF capacitors in RC coupling.

Then I changed the driver tube from 6f6 to 6v6 and to 5881 (6L6) and each time a more powerful driver sounded better, bigger soundstage with better instrument separation. 

A bit late to the party here, but it's a topic near and dear.  I've had Altec 604-8G in one of my systems for many years.  One day a friend and I did some trading, and I wound up with an Alan Eaton SE45 stereo amp.  It was quite pleasant and I enjoyed listening.  He had also brought over a 300B amp made by BEZ.  It was not impressive, very veiled, mushy, etc.  I kept the Eaton amp until I decided to make my own SE45 amp from vintage parts.  Output trannies are Triad HSM-79.  Borrowed and merged bits of circuit design from various sources, and the result was an amp that outperformed the Eaton amp, both on the bench (output at clipping and sq waveform) as well as sonically.  If you're wondering, I listen first, then measure.  I don't recommend scratch building unless you enjoy the journey, but the point of this comment is buy a kit with the best output transformers you can afford, as they are the heart of any single ended amplifier.  As for wattage concerns, 1.6 wpc does seem a bit lean, but if you're speakers are 95 db at 1 watt, they'll be 85 db at 1/10 watt.  Distance from speakers matters, room sound absorption matters, but unless you're looking for slam at disco levels, SE is a fun part of the audiophile journey.  Life is short, build the kit, savor the results.  I also have one of Dennis Had's KT88 Inspire amps, and it brings a little more punch, with up to 6x more wattage on tap.  All good fun.

The mention of a directly coupled cathode follower by atmasphere is interesting.  Today, I just happen to be looking at the schematic for an old Wyetech SET amp and noticed it had a directly coupled cathode follower to the grid of the output tube.  

Looking for stories about your low-watt amp journeys.

Using 100db Volti Rival for investigation tube sonics, chosen for its neutrality and affordability - I want to hear tube differences starting with flea at SET amplification.

Started with 300b because it’s the most notable SET. Purchased a used Coincedent Frankenstein 300b v2 because of its high performance/price sold directly.

Debating purchasing a TEKTRON TK TWO 2A3/50S-I VACUUM TUBE - 2a3, 45, 50, 300b - to investigate other flea watt SET tube types

Also debating DECWARE Model SE84UFO25 - long wait but great sonics and can tube roll