Balanced vs standard power


Searching for an Isolation Transformer 10 or 15kva. I have the budget for Equitech but I'm sold only on the benefits of isolation and not "yet" on the benefits of balanced power unless one is recording live musicians. My rationale is that most if not all audio components are not designed with balanced power so they may be optimal performers with standard power and lesser performers with balanced power. Until someone does a side by side comparing isolated balanced to isolated standard power we may never know.

I have read the various threads regarding isolation transformers from Equitech 10wq, MGE Topaz etc, and the Euqitech stereophile review. For larger non-balanced options there is Ultra K 600 with K factor correction and triple shielding from the Controlled Power Company. They range from 5 to 25 kva.

I think supersizing Isolation transformers for audio is not well recognized yet because no one has done the necessary review/ comparisons to determine the performance curve of Isolation Transformer size to Audio Performance. Although Isoclean advocates the use of two of their Isolation Transformers for each piece of equipment. Maybe they're trying to tell us something or just sell more transformers. 10 KVA is "plenty" for my system according to Martin at Equitech, but "plenty" is not quantified enough to convince me, so I 'm leaning toward the 15kva on the Ultra K 600 from Controlled Power about $4000 vs Equitech 15 kVA at upwards of $14000.
natan6355
Natan6355,
Hello and congratulations on your sucessful implementation of the balanced power (BP) transformer. Is the size overkill? I `d say yes (for home audio components) but absoluttely harmless(and hey, it`s what you wanted).Your results don`t surprise me but are what one would expect.

As I wrote earlier in this thread my experience with a BP transformer (in use 3 years) has been a completely positive move 'without any downside'. The improvement was immediate and substantial, and when I tried putting the components back into the wall outlets(dedicated 20 amp service) the decline in sound is undeniable. I don`t understand what is 'debatable' about balanced AC power at this point.
I, also, recently joined the BP ranks. I’m using a Signal DU-10 transformer wired for balanced power with electronics that can potentially draw a max. of 3400kVA. My findings with BP are similar to that of Zmanastroomy & Charles1dad. By adding a 220uf capacitor to the secondary side of the transformer, this made a HUGE improvement to the sound. The improvement with the added capacitance is far more impressive than BP alone, which was already a significant upgrade. The down side with the added capacitance the trannie generates more heat and noise.
By adding a 220uf capacitor to the secondary side of the transformer,
03-10-12: Norm

Norm,

A word of caution when adding capacitance in an AC circuit.
Two things that can happen.

(1) The capacitor can raise the output voltage.

(2) Too much capacitance causes the voltage to lead the current causing a leading power factor. Result is a low power factor.... That can cause overheating of the secondary winding of the transformer.
.
Jim -- Good points, but in no. 2 shouldn't "lead" be "lag"?

Re the 220uf, that corresponds to an impedance (capacitive reactance) of 12 ohms at 60 Hz. That will certainly pull a lot of current through the transformer, but I suppose it's within reason given the 10 kVA rating of the DU-10, and the 3.4 kVA load. Assuming the breakers and wiring can handle it all, of course!

Best regards,
-- Al