Owens Corning 703


I am using this material to build out a music room in the basement - I have glued/tacked 1 inch sheets to my open ceiling between floor joists. My designer has suggested covering the ceiling with cloth to use the whole ceiling area as diffusion.

My question is will this keep fiberglass from floating around since there will be approx 5 inch gap between the fiberglass and cloth? I know most applications for bass traps for example, involve adhesion of the cloth to the fiberglass board...thanks.
pops
The owenscorning will stay in place unless phsically disrupted . A fabric will look best and would trap any loose particles if for any reason it got disrupted .
Try rock wool instead of fiber glass, products such as Roxul Safe n'Sound. The rock wool is less of an iretant than fiberglass.

As for facing materials, for my bass traps I bought fabric from Ikea and used it to cover the Roxul. Just be sure that the material has a tight weeve.

For my ceiling I do the following, I suspended two layers of insulation between the joists and left an air gap between the insulation and floor above. The first layer looking from below is a 3/4" thick fiberglass ceiling panel which is faced with a thin dimpled sheet of plastic. The plastic provides a clean surface for the ceiling. The second layer is 3" thick Roxul. check out my system picks to see the end result.

This has deadened my room substantially but, my room is small and it needs it.

I hope this helps
Thanks Nick, nice room. i have a large space in my basement, alot of area to treat. 703 is already tacked/glued between the joists - the is a Rives design, hopefully another 30 days it shoud be complete - been working on it since March...
Good luck with completion of the project. I hope you post some pics in your system page when it's done.