I use .5-.75" MDF, zip ties and/or hot glue.
Drill holes though the MDF for the zip ties then use a router on the bottom to cut a .25" line between each set of holes so the board can sit flat. Or if you are mounting the crossovers externally, you can built a box out of red oak or another nice wood.
As for chassis wire, what are you using for speaker wire?
I normally use Neotech solid core, but may try Duelund next time. When using solid core, remember to twist or braid them.
Drill holes though the MDF for the zip ties then use a router on the bottom to cut a .25" line between each set of holes so the board can sit flat. Or if you are mounting the crossovers externally, you can built a box out of red oak or another nice wood.
As for chassis wire, what are you using for speaker wire?
I normally use Neotech solid core, but may try Duelund next time. When using solid core, remember to twist or braid them.