CM LABS Amplifiers, any opinions?HELP? ?

Yeah, I had a 911 back about 20 years ago. 150 wpc, weighed a ton. It sounded awesome to me, but that was back in the days when I was making the transition from mid-fi to high end. I loved to watch those big ole meters swing with the bass when I cranked that sucker up. I still have the matching ss pre stuck away in a closet somewhere. Looked to be bullet-proof, but a lightening strike cooked mine.

swampwalker: aha! you shoulda' had your cm pre in a faraday cage (like my listening chair). it might still be around today and worth millions (in argentinian currency, anyway). -cfb

Well shucks boys, it seems as tho I experienced a brain fart as I was composing my earlier post. It was the amp that went to audio heaven. Pre is still with us, altho unused for many years.

CM Labs 911 Power Amplifier.
Output power per channel (both channels simultaneously): 100 watts into 8 ohms, 60 watts per channel into 16 ohms, 90 watts per channel into 4 ohms. Total available peak power: 1.1 kilowatts.
Power bandwidth:: 10 Hz to 30 kHz +0, -3db (minimum) at less than .5% total harmonic distortion: 0 db reference at 1 kHz, 0 db at rated output.
Frequency response: 20 Hz to 20 kHz +/- .5 db; 1 Hz to 100 kHz, +/- 3 db.
Itermodulation distortion: Less than .5% at power levels between 1 watt and 100 watts equivalent single frequency power into 8 ohms load (60 Hz mixed with 6 kHz, 4:1)
Damping factor: Greater than 200 for 8 ohm load, 20 Hz to 20 kHz.
Overload response: Recovery from 100% clipping overload, 10 microseconds maximum. Automatic protection circuitry provided against short circuits, open circuits and grossly mismatched loads.
Input sensitivity: Independent level controls provided for sensitivity adjustment of each channel: Maximum sensitivity: 1 volt rms to 1.65 volts rms input required for full output in 4 to 16 ohm loads, respectively.
Input impedance: Greater that 50,000 ohms.
Hum and Noise: Better than 70 db below full rated output.
Power consumption: 120 volt, AC only, 6 amperes at full output, 70 watts no signal.
Solid state complement: 8 silicon output transistors (23 transistors in total), 2 zener diodes, 3 silicon diodes and 2 silicon rectifiers.
Overall dimensions: 14 3/4" wide X 8 1/8" high X 11 5/8" deep.
Weight: approximately 40 pounds.
Finish: Brown enamel and brushed gold anodize.
Hope this helps.

I have a 925 that i got about 3 years ago.straight off there shelve.it was still brand new.I dont use it thou cuz i seem to smoke everything i put on it.way powerful.I cant find anything on the net about it.I do know this thou it's back when they were in madison county alabama.I had the paper work for it but i lost it.Can you help me with any info?oh there now called meteor light and sound.They don't make amp's anymore.