Amp for Paradgim Studio 100

I have the 100 v.2 teamed with a Mark Levinson #23 its 200 watts minimum make these 100's shine, extremely detailed and powerful thru all the octaves,very clean and tight bass,perfect mids and those extended highs,all dead quiet when changing a CD,incredible sound, very well matched setup and the Mark Levinson #23 can be bought used at around 2k .This is a perfect match in my home and can rock the entire neighborhood effortlessly and without one iota of distortion or fatigue....Good luck in your quest

I ran my Studio 100 v2's with a Classe CAP-151 solid state amplifier with good results.

As I said earlier (kzx0v6) I am running the Anthem MCA-20 and am reasonable happy with it. Would I prefer a Bryston or Bel Canto or some such - certainly but I've run out of cash. I found cabling made a huge difference for the better on my system. I bought the Virtual Dynamics Audition package ( http://www.virtualdynamics.ca )which includes 3 PC's, 2 IC's, and speaker cable. I upgraded to a biwire cable with banana ends. A Musical Fidelity A3CD and a Sonic Frontiers Line 1 flesh out the rest of the two channel system.

Two things:

1) I don't find my system bright at all set up the way I am at this time. I have thought it bright in the past with different configurations. Sound is rich and full from top to bottom.

2) My system sounds fine at moderate volume with no large hole in the midrange. Does it sound a little better when you spank the volume? Yes, but I live in an apartment and do so at my own risk as to where I live.

When I bought my CDP I auditioned the Arcam 72T and liked it a lot. I prefered the Musical Fidelity to the 72T though. I was able to A/B them at my dealer. I did not think the Arcam bright in any way. I thought it had just a bit better bass than the MF A3CD. Where the A3CD excelled was sounding a little closer to analog with much better soundstaging.

I strongly suggest you look at some really good cables like the Virtual Dynamics once you have your amp. I was truly shocked at the difference they made and can't recommend them enough.

I use the McCormack DNA-225 amplifier with my Studio 100 Ver2 speakers. The amp has plenty of power and can get the room painfully loud with ease and holographic imaging with no signs of distortion. The amplifier has complete control of these speakers. Excellent amplifier! The studio 100's dip around 3 ohms in the bass region, where the DNA-225 will produce over 400 watts for them to give off some of the best sounding and hard bass that is only attainable using a subwoofer.

Hey Asi tek, what brand preamp are you using with this combination?