Can anyone tell me about the Proceed PAV good /bad

The PAV/PSDS is a very good audio video combo. It is no longer supported by Proceed. If you are going in that direction I would reccomend the AVP which is still getting software upgrades. If you are looking at two channel as much as I loved the PAV I would really look around and with whatever you have budget get a more up todate unit. Look at some of the used ML or CJ units.

John, the buzz and hiss go away when I disconnect the RCAs from the output of the preamp to the amp. I didn't have this problem with my Conrad Johnson PV4 and now I do. All of my power chords and cable lines run through a line conditioner.

I'm not saying it isn't the preamp, it could be, but ground loops are tricky. For instance, I originally thought my preamp was the problem. I had a buzz coming through the speakers, when I unplugged the inputs to my amp, the buzz went away. I unplugged the inputs to the preamp one by one, the buzz stayed. So I thought it must be the preamp. I went to try to float the ground on the preamp, but noticed the buzz got louder when I unplugged the preamp. Strange. So then I thought maybe I needed Cardas Caps, I thought maybe the open RCA/XLR fittings on my preamp were picking up noise. Wrong, Cardas Caps did nothing. Then I unplugged my cable tv main line coming into the house, viola, buzz gone. So I bought a MIT Iso-LinQ to isolate the ground from my cable tv, it worked, no more buzz.

The bottom line is some equipment is more suspect to ground loop noise. There may be something wrong with the preamp, maybe it's just the system. I bought a brand new preamp direct from Cary about 12 years ago. It had a buzz. I sent it back, they could find nothing wrong and sent it back. The buzz was still there. I sent it back and again they told me there was nothing wrong. All I know was when I plugged my Aragon 24K in there was no noise, with the new Cary, there was. I figured out years later, that it was my system, not the Cary that had the problem. The Cary was just more sensitive to ground loop hums than the Aragon. When I had the same problem with an Audio Research preamp a couple years later, I realized that in my system, tubes were more prone to ground loop hums. With work, I could eliminate the hum, but for some reason they always picked up noise, more so than SS preamps. I don't know why.

I don't know if any of this helps, all I can say is try isolating the cable tv line and floating the grounds before you isolate and blame the preamp. It could be a ground loop hum.

Regards,
John

John, thanks for the info, I will try some of the things you suggested but I really want to get an AI preamp. I am trying to convince my sig. other that my current pre is no good with my system. hehe

In that case, then by all means, your current preamp IS broken. You have to get a new one.