2. amps-preamps
  3. 1049118322

Amplifier speaker relay problems.

Hi, I am working on an Niko Alpha II amplifier it is an older amp with the two large VU meters on the front. There is a problem when powering up that one chanel may not work. I have tracked this down to a relay that is in the speaker output path and is 24volt dc with two normally open contacts. It is on a printed circuite board and I wish to change it as cleaning did not help and I am afraid it may be degrading sound when working if not providing a good path. I uderstand this relay helps prevent thump on powerup and the sound from dithering out on shut down. Thank You for any advice.
guycom
guycom OP
20 posts
 
Thanks Bob I will give that a try first,
Regards, guy
guycom OP
20 posts
 
Update- crocus cloth worked. Also corected a low left channel at slight volumes. Thank you both for the advice regards, Guy
bob_bundus
1,834 posts
 
you're very welcome Guy - wish that they were all this easy!
dsrjohn
8 posts
 
Not sure anyone will respond but...A friend has a Sony TA-F3A amp. She says it was acting up - i.e. after powering up, it would take quite a while before she would hear the characteristic click and she would get sound but now it never clicks. Sounded like a relay problem. So I opened up the relay, blew some contact cleaner and that did not help. The contacts look to be gold plated so they shouldn’t even be dirty. I removed the little spring (see the pics) and sure enough, the contacts look very clean. Next test was to see if there was any sound - so I added a source and listened through earbuds. No sound. However, if I manually (using insulated pliers) flip the contacts in the relay so that they make contact, I get good sound out of the earbuds. So for some reason, the relay will not flip. It does not seem to be because of a problem in the circuit, as I get good sound out of it. So either the relay is gone or something upstream of the relay is gone. Any ideas?
dsrjohn
8 posts
 
Seems that I cannot add pics.
More to discover