How to pick which brand of 6550 tubes to purchase


I have a pair of Ray Lumley M-100 amps. Have used two complete sets GE 6550 for close to twenty years. Need new tubes. Which tubes would you recommend to purchase? Any knowledge of the sound character of the different models. I like the accurate/neutral type of sound versus the too valve sound.
dcaudio
Thanks everyone. Particulary the recent article comparing 6550's sound interesting. My guess is that I have 1,000 to 2,000 hours after 20 years. I did not count. Recently listening as much as 10 hours per month. My voltages are very high 620 Volt. My repair shop said this makes it much harder to find a tube that will last. He said the Tung Sol are not very good with high voltage.
OK, now I've had one of my Svet 6550C's fail before its time was due. Luckily, I happened to walk back into the room and glance over toward the rig just as the tube began lighting up bright orange inside - I was cranking pretty loud at the time. I ran over and killed the volume and the amps. The music had actually continued to play without distortion right up until I doused it, but after allowing things to cool down and swapping out the light-show tube, the output fuse was blown when I tried to turn the amp back on. Fortunately, a new fuse took care of the situation - there were no blown resistors or anything. Why the tube went however, at only about 10 months old, I cannot say.
I just retubed my Conrad-Johnson Premier 11A amp with the new Svetlanta (now a three letter logo) 6550 C tubes. Wow, what a difference over the stock GE's. The tubestore has them in stock, got a 'perfect quad', which means the tubes are all matched to one plate voltage (52 in my case). This is a great feature if you have to adjust gain. The old tubes were not shot, but C-J recommends changing them every 3 years of normal use.
Regards,
I have never been a fan of 6550s but just replaced Svetlana KT88s with RAM - tested Sovtek 6550 WEs and am most pleased Sound like clear-tops to me. Take a listen if you are able.