Carver Pro ZR1600


Two of the three amps I ordered for my multichannel setup arrived today so I had to do a quick checkout driving the MG1.6 fronts and center. WOW. Everything you have heard about these amps is true. Perhaps, as others have said, they are particularly well suited to Maggies.

I did have a slight hum, as others have experienced, but activating the "ground lift" switch totally eliminated it. The amp is set up for balanced line input, and I suspect that the hum problem happens when you use a single ended input signal. (Not really a problem because the ground lift switch fixes it). The fan noise would be anoying if you can't put the amp in the cellar as I do. It is reported that in home audio applications you can disconnect the fan without overheating the amp. There is also a mod offered which replaces the fan with one that is much more quiet.
eldartford
Eldartford- I highly recommend you pick up some Neutrik Speakon NL-4FC cable connectors for you speaker connections. The CarverPro is set up to accept these. They cost about $5@ and are easy to install.

I think waiting to get a handle on the amps before doing any mods is a wise move. Stan Warren is reported to
be looking at these amps. I'd wait until a real pro like Stan comes up with a mod.

Have fun.
Kana813...Neutric Speakon connectors certainly look like excellent devices, but I do not need to frequently connect and disconnect speakers, so I think that bare wire clamped into the binding posts is probably best. (Least number of contacts, per sean's rule).
DMason - I listened to the Carver mods at The Eighth Nerve. The mods have been discussed at Audiocircle.
El: Try using solder as an interconnect rather than a speaker cable. The gauge of the solder used would be more appropriate for line level signals than for the much higher current levels of a speaker connection.

If i remember correctly, i think that Jennifer Crock of JennaLabs did this with several different solders. According to audiophile folk-lore, she preferred Cardas solder to the others that she tried in this manner.

As a side note, take a relatively long yet identical length of various generic and high quality solders and measure the resistance of them using precision test equipment. My business partner kept telling me that "solder is solder", so we did this along with some other tests at the shop using some of my HP test equipment. Needles to say, he was pretty amazed at the differences in conductivity between various solders. Then when i explained to him the differences in metallurgy in various solders, the variances in how different solders dry, bond to the surface and how well they hold up over time, he wanted to verify this. After watching how various eutectic and non-eutectic solders performed in these areas, he was pretty much a "convert" as far as "high tech" solder goes. Sean
>
All that being said, I would like to point out once again, that after a year and a half owning the amp, -as one of the original heretics who "dared" wade into the dark pro-audio waters, this is the best amp I have ever heard, owned and heard plenty, and plenty good. It is for this reason that I caution that the amp is so damn good, for those of you contemplating one, please note, the mods are by no means "necessary" for ultimate enjoyment. And yes, it STILL reminds me of an exceptional tube amp, coming dangerously close to SET, "to these ears, on this equipment, in my environment." I know what real instruments sound like, and have the advantage of perfect pitch. The amp 'matures' over a six month period....Passive preamplification and non-oversampling source for the Redbook crowd most strongly advised. Value Value Value.